Installation Info
1. Prepare hole in panel as shown.
2. Pass shaft of latch through hole from back
side of panel, fit alignment pin into notch, apply lockwasher and thread sleeve
over shaft from front side of panel.
Note: Alignment pin is for proper orientation
and alignment of latch during installation only. When tightening sleeve, be
sure to hold latch firmly in position.
This completes installation of tool actuated style. For knob style, orient shaped
hole in knob with flat on shaft and press knob fully onto shaft.
| Series |
ØL
|
M
|
Part Number
|
| 40 |
11.1(.437) -
11.3(.445)
|
14.5() -
17.5()
|
|
| 60 |
15.9(.625) -
16.1(.633)
|
21.8(.85) -
26.6(1.03)
|
|
|
Materials & Finish
HOUSING: 1010 Steel, zinc plated plus sealer.
SLIDE and PINION: Die-cast zinc, black organic
coating.
BASE: Die-cast zinc with chemical protective coating.
SPRING: 302 Stainless steel, passivated.
RETAINER: Spring steel, zinc plated plus yellow
chromate dip.
LOCKWASHER: Spring steel, DACROTIZED
†.
SLEEVE: Low carbon steel, black organic coating.
KNOB: Nylon, black.
†Registered tradename of Metal Coatings International,
Inc.