Installation Info
PANEL PREPARATION:
TYPE A INSTALLATION SHOWN:
FOR TYPE B INSTALLATION:
1. Rotate housing and pawl sub-assembly 180° around
axis of shaft.
2. Rotate handle, shaft sub-assembly and actuator
sub-assembly 90° around axis of shaft.
If lock assembly is used, remove hex nut from lock and angle LOCK PAWL through
the hole, then drop hex nut back over lock pawl. Slide lock pawl through slot
in housing (bend lock pawl if necessary) and tighten hex nut.
Materials & Finish
HOUSING, ACTUATOR, PAWL, and PAWL FOOT: 1010 Steel,
zinc plate, chromate plus sealer.
STUDS, NUTS and PAWL SCREW: Steel, zinc plate, chromate
plus sealer.
LOCKWASHERS: Spring steel, zinc plate, chromate
plus sealer. PIN: 303 Stainless steel, passivated.
LOCK HOUSING: Die-cast zinc, chrome plated or black
powder coating (see part number listing).
LOCK PLUG: Diecast zinc and brass, chrome plated
or black powder coating (see part number listing).
LOCK HOUSING NUT: Die-cast zinc, chemical protective
film.
LOCK PAWL: 1010 Steel, zinc plate, chromate plus
sealer.
LOCK PAWL SCREW: 303 Stainless steel, passivated.
HANDLE: ABS chrome plated or black (see part number
listing).
SHAFT: Low carbon steel, zinc plate, chromate plus
sealer.
CUP: 1010 Steel, chrome plated or black powder coating
(see part number listing).