Installation Info
PANEL PREPARATION:
INSTALLATION:
1. Prepare panel as shown.
2. Place Sealing Washer under flange of housing
(if required).
3. Install housing in panel with LUG oriented
as indicated for Type A or Type B installation.
4. Tighten mounting nut to 10 N•m (88.5 in-lbs.)
MAX.
5. Install O-ring on drive stud (if required).
Southco recommends that you use a commercial O-ring lubricant.
6. Place Drive Stud in Housing, orienting indicator
dimple toward frame.
7. Place Detent Washer and Pawl on end of Drive
Stud. Install Hex flange screw with a tightening torque of 5 N•m (44 in-lbs.)
MAX.
ACCESSORIES:
NOTE: To calculate your total grip: add bracket
thickness to your door thickness.
NOTE: To provide sealing: use two Flange Gaskets
and add compressed thickness of each Flange Gasket and bracket thickness to your
door thickness.
PULL-TAB (For use with Quad Panel
Latches) |
Use to provide a convenient finger grip.
Helps to lift or pull Quad® Panel Latches . |
MATERIAL & FINISH |
PART NUMBER |
PULL-TAB: Nylon; black
|
E5-18 |
|
PADLOCK BRACKETS |
Padlock Brackets do not accommodate Pull Tab or Sealing Cover Accessories.
|
MATERIAL & FINISH
|
PART NUMBER |
300 Series Stainless Steel. Black Powder coated.
|
E3-77-101-31
•
|
|
PADLOCK BRACKETS (Round) |
Only unassembled styles can be used
with the round bracket. |
MATERIAL & FINISH |
PART NUMBER |
300 Series Stainless
Steel. Black Powder coated. |
E3-77-102-31
• |
|
Materials & Finish
DRIVE STUDS: Chrome:
Die-cast zinc, chrome plated.
Black: Die-cast
zinc, natural; head is black powder coated.
HOUSING: Die-cast zinc, acrylic latex sealer.
PAWL: 1010 steel, zinc plate, chromate plus sealer.
DETENT WASHER: 301 Stainless steel, zinc plate,
chromate plus sealer.
HEX FLANGE SCREW: Low carbon steel, zinc plate,
chromate plus sealer.
MOUNTING NUT: Die-cast zinc, acrylic latex sealer.
O-RING: Buna-N, black.
SEALING WASHER: Neoprene, black.