Installation Info
• Adjustable knuckles must always be mounted to
the door.
• Front mounted adjustable knuckles must be disassembled
before installation.
• Use hole plugs to deter unnecessary adjustment
and enhance appearance. Hole plugs press into screw sockets with thumb pressure.
Note: These hinges can be mounted on either side of door.
To adjust hinges, Pivot adjustable knuckle with respect to the base to desired position, then tighten knuckle in place with a 4 mm or (5/32) hex wrench. Recommended tightening torque of clamping screw is 4.5 N•m (40 in.-lbs.)
To assure lift-off capability, the pin of the fixed knuckles must point
up when installed on frame.
For non-lift-off mounting, the pin of one fixed knuckle must point in a direction opposite the other(s) when mounted to frame. One of the fixed knuckles must be installed AFTER door is hung.
Note: Either F Dimension or G dimension must be less than 19.8 (.78) for the door to open a full 180°. * Dimension will vary as + dimension is adjusted through its range. The door and framedesign must allow for this variation.
Materials & Finish
KNUCKLES and BASE: Die-cast zinc, black powder
coated.
WASHER: Nylon, black.
HOLE PLUG: Thermoplastic Elastomer, black.
CLAMPING SCREW: Stainless steel, black oxide.
CLAMPING NUT: Low carbon steel, zinc
plate, chromate plus coricone sealer.